Quote Originally Posted by genec57 View Post
Boxgods,
Can't get to a camera right now. The four inlet/outlet fittings adjacent to the pump - no problem. Across from the pump are the two ports meant for fluid charge/drainage.
It is these two that I refer to. I have my TIII configured so that it is on its side. On the pump side both outlets are used and one of the inlets. On the other side I am using one port as an inlet and the other as a drain. In both cases in order to use a compression fitting I had to ream out the side panels to make space.
I have an extra port on what is now the top for adding fluid.
Am I clear now, I hope? .
That channel you had to dremel out was designed as an overflow basin for refilling. You could of used some G1/4 extenders or antitwist adapters though and probably saved the cutting.