How is everyone else setting the memory timings?
I thought this would be like my Asus board where you can leave what you don't know how to configure at auto and change the timings you do know. But it's either Auto for everything or full on manual mode for everything.
I notice when i change the memory speed from 1066 -> 1333 -> 1600 that there are two columns of values next to each timing that also change. These columns, "SPD" and "Auto", are next to the column where you actually change the values:
I was thinking I could use these values to manually set the timings, but (unlike the screenshot above) some are drastically different comparing SPD with Auto... I know the SPD values are programmed into the memory, but where is it getting the Auto values from?
Reply With Quote
Bookmarks