My mounting kit

[Jor3lBR]

the evaporator is under that insulation. those two half peice foamy things "sandwhich" the evap and the lip machined in it fits over the evaporator. so take off enough of that insulation to show just the evap, then slide over the mount (the hold down plate and the muff) then put the two styrofoam type things over the evap, then slide down the mounting till you have a tight fit then post a picture of it so you som1 can see if all is in order

cheers

Thanks Teyber!

When you say "take of that insulation to show just the evap" you mean cut it off with scissors to show this: http://i44.tinypic.com/mhyo42.jpg

So the sandwich will be made on the base of the evap leaving most of the head exposed? On pic one you can see that the evap is not a tight fit on the plastic head so how should I insulate the tip there?