Could that be what causes my problem which is as followed:
My Powercolor 4870 is under water with the new EK FC block. Before vGPU mod I ran it at 850/1000.
Today I did the vGPU mod, and where ATI Tool would artifact above 850 before, I was now able to run ATI tool artifact free at 940MHz. (See picture).
My problem is, that eventhough ATI tool runs flawless, no game will run for more than a few secounds. Everything above aprox 1.37v will make the screen go black or the displaydriver to stop working.
It dosent matter if I only uses the same 850mhz as I did before the mod.
Lowering mem speed dosent do anything for me either..
Would it make any sense to try another BIOS?
Really hope you guys are able to help me out here
Reply With Quote
Bookmarks