Hey all, got my 4850 today and before I headed to work, installed it quick and ran a couple of benches. Problem is, after the benches (3dmark 03 & 05), I get artifacts when back in 2D. Basically I have a lot of pixels flashing red and green.
During the benches, there are no artifacts, only after I'm back in 2D.
I don't think it's a heat issue, simply because it was fine during the benches and didn't seem to get too hot (unable to get temps either - will see why later),but I had little time and I'm sitting at work now.
Just wanted some input so I might have something to fall on when I get home to try and troubleshoot. Any help, suggestions is greatly appreciated.