Just want to put a tempplate of my settings... so anyone knows what im upto in case of questions etc
This is 1hr OCCT 2.0 MIX stable, and i take 1hr mix as atleast 8hr of prime or orthos.
noticed that Large FFT did NOT crash where OCCT did after mintutes.
AI Tweaker
Ai Overclock Tuner: Manual
CPU Ratio Setting: 9.0
FSB Strap to North Bridge: 333
FSB Frequency: 467
PCIE Frequency: 105
DRAM Frequency: DDR3-1869Mhz
DRAM Command Rate: 1N
Dram Skew Control:
CLK SKEW channel A2: 200ps
CLK SKEW channel B2: 225ps
DRAM Timing Control: Manual
CAS# Latency: 7
RAS# to CAS# Latency: 6
RAS# to PRE Time: 5
RAS# ACT Time: 16
RAS# to RAS# Delay: Auto
REF Cycle Time: 72
WRITE Recovery Time: Auto
READ to PRE Time: Auto
DRAM Static Read Control: Disabled
DRAM Dynamic Write Control: Disabled
Ai Clock Twister: Stronger
Ai Transaction Booster: Manual
Performance Level: 06
Pull-in Of channel A Phase 1: Disabled
Pull-in Of channel A Phase 2: Disabled
Pull-in Of channel B Phase 1: Disabled
Pull-in Of channel B Phase 2: Disabled
Voltage Settings
CPU Voltage: 1.45~
CPU GTL Voltage Reference (0/2): 0.69
CPU GTL Voltage Reference (1/3): 0.695
CPU PLL Voltage: 1.5
FSB Termination Voltage: 1.10 (actually works better with lower voltage here, atleast on dual)
DRAM Voltage: 2.06
NB Voltage: 1.55
NB GTL Voltage Reference: 0.61
SB Voltage: Auto
Clock Over-Charging Voltage: 0.90
Load-Line Calibration: Performance
CPU Spread Spectrum: Disabled
PCIE Spread Spectrum: Disabled
Advanced > CPU Configuration
CPU Ratio Setting: 9.0
C1E Support: Disabled (take this off)
CPU TM Function: Enabled
Vanderpool Technology: Disabled
Execute Disable Bit: Disabled
Max CPUID Value Limit: Disabled
Reply With Quote
Bookmarks