NEW RESULTS::: Lowered the NB speed and got stability.
Instead of playing with the different memory speeds... and timings... et al. ad nauseum. (I am now SICK and TIRED of memory timings.)
I didn't know how to lower the Northbridge speed:
In the AOD you have a setting called NB-VID... but it won't save if you attempt to change it. (You have to change it in bios. See DaveBurts post.) But increasing the NB-VID made my system VERY unstable.)
In AOD there is also a HT Multiplier which lowers the HT Link Speed but it doesn't touch the Northbridge speed. There is no Northbridge slider. Dang it.
NOW: In the BIOS there are two settings: Memory controller (9x, 10x, 11x etc.) and also HT Link Frequency (1.8, 2.0 etc.) Apparently BOTH of these must be changed at the same time. If you decrease the Memory controller lower than the HT Link frequency the BIOS will change it back when you reboot. But if you change the "Memory Controller" to 9x (1800) and the second to 1.8... and save it... the northbridge AND the HT Link Speed will be 1800.
Apparently the BIOS "memory controller" == AOD's Northbridge and the BIOS HT Link Frequency == AOD's HT Link Speed.
I had a scary close call. I decided to raise both to 2200 just to see how unstable it would be. Hey who knows... it might have been more stable. Anyway BOINK. SPLAT. I had to remove the Phenom and boot with an X2-4800+ before I could get the Phenom to boot again. SCARY STUFF.
OKAY YEAH!
Using 1800Mhz NB/HT I can run Prime95 (Blend) without getting errors at least in the first few hours. This is running the memory at the FULL DDR2-1066 speed. (Before even if I put in old DDR2-533 memory it ran longer but eventually rebooted. Using 1066 memory it would error after a few minutes.)
In addition, because I'm impatient:: while 4xPrime95 (blend) ran for about an hour I kicked off the Everest stability test. That worked okay but it really slowed down the Prime95's. Then I ran the NVidia "Cascades" demo which mostly uses the GPU. All of these ran together. (Actually I'll kick them all off together when I go to bed. Maybe run the AOD stability test at the same time. They'll ALL run slow if you run them all together... but they should run without errors and without rebooting.)
NOTE: If I try running multiple stability tests using the default 2Ghz Northbridge/HT the system WILL reboot after a few moments.
SO I THINK I HAVE FINALLY FOUND STABILITY.
Sure I don't like the lower 1.8Ghz NB/HT... but at least this system is now running stable with this CPU, this MB and this memory. NOW I have a "zero" point and can "play." I know there is no "unknown" something that makes the system completely unstable.
So why do I need a lower NB?
Possible Reasons:
1. A Bad CPU
2. The BIOS needs updates
3. G.Skill F2-8500CL5D-4GBPK memory doesn't play well with AMD
Oh... pretty... and BEATING the crud out of the system. (This is a dual monitor... doing a screenprint will show both screens as if it was one screen. OH NOES... only 11.2 FPS in the game... THE TRAVESTY!)
Oh wait... I need some HD Tach in there to test the RAID hardware card. :-)
Reply With Quote
Bookmarks