Quote Originally Posted by aGeoM View Post
Coincidence or not, my 9850 died after completed all benchs in SiSoftware Sandra XII 2008 SP2 (14.20a), then I restarted the system to set 12*250 for 3000, in witch I was but at 15x200, to compare, never booted again, [C1] error.

1st i tough was the bios, since it was the last thing I did, EZ-clear CMOS, jumper clear, and then hot-flashed, no way C1 all the time, Voltage was: for CPU-VID=+105.14 and for NB=+103.7, I could not figured out what happened.
Sheas, I see one parallel to my C1-9500. He also stopped working at relative low volts in comparison to what i had applied before.

You plan to RMA that CPU or do you think it was your fault only? I mean both board and the chip are build for overclocking and you ran your cpu in specs at modest higher voltages.