I'm testing it with my QX 9650

So far I got three issues:

1) Why is the Tjunction on my chip being up now to 105C? Is that correct? I thought the TJunction was 100C.

2) There is a difference of an extra 5-6C now on the cores. It is actually matching what the Sensor monitor shws if I use Everest. So what is correct,either 0.95.4 or 0.95.6?

3) The VID is now shown, great, but it always stays the same no matter if I'mactually stressing the chip.

I can assume that by adding 5-6C extra it is adding 5C extra to my Tjunction (100+5=105C)

That's my feedback...

Any other tester running with the same issues on your Yorkies.?