Quote Originally Posted by Johnny Bravo View Post
So are you saying that you can solder say a 1Kohm variable resistor in parallel with the 681ohm resistor in the pic and this will "fool" the DAC ?
It seems to be working just fine. (i can't say more, there is nothing on the "typical application circuit" in the datasheet for that pin.

Quote Originally Posted by |RickY| View Post
thanks for info i'v cheked the 681ohm resistor has 20 ohm to ground from 1 side and 700 to ground on the other side, must be just solder 1k or so to ground on 700ohm side
or solder in paralel on that resistor.

i'm a litle confuzed, it will be needed vid mod on cpu? you just talk on this mod and vdroop mod, why no v-core mod? you substitute vcore mod by vid mod on cpu?

realy thanks

Solder a wire on each red points to your VR (set at 1000 Ohms) then decrease the resistance.
No need VID mod.
For the vdroop it is much better with, but it's not needed.
Do not use the other vcore mod, only that mod (without OVP).
That vcore mod only work when you set over 1.6000v in the bios.

(when i hit 2.10v (DMM) the monitoring say 0.024v)

PS: and thx to the dude of the pic (link on my previous post)

Again, lot of vcore = dangerous, beware.
Voila