Quote Originally Posted by deathman20
Only 10088 score I see showing all drivers and that for the X1800's was a ThickBrit and that was an XT pulling 722/810. I think Futuremark has some screwed up results because im seeing more and more results now above my score that where posted earlier then mine.

What so what you really running your X2-4400 at just the 2.4Ghz in your sig or the 2.7Ghz you mentioned? What type of cooling you running? What voltage? I was just able to squeeze 2.7Ghz out of mine runs on the very high end in benches of 48C but otherwise max I've been able to get it was 46 for a split second doing 3D Renderings. Its stable too but ya im sitting in the same boat as you, I can get 2.8ghz to run, in windows and all but throw a bench at it, and say hello to BSOD (god been a long time since I seen that screen).

I'm just glad I got 2.7 since thats what I really wanted at least.
Sorry - meant to type 10028 - here is the link:

http://service.futuremark.com/compare?3dm05=1490320

As far as the X2 - I run it at 2.4ghz as my base setup. I just installed the Zalman 9500 - which is amazing. Temps dropped 10-15 degrees. I am sure I could go morefor my base. I have to bump the volts up to 1.3 to get that stable, but it is very easy to hit. Temps are low 30's - sometimes idles at 29. Load is mid 40's. It hits low 50's if I give it 1.55 volts to run 2700 or 2800. Definitly not a temp issue. It is just one core that hurts me. I cannot run prime95 with the 2700 tests but 3d05 works most of the time. I am sure it is a memory or other issue I am just not savvy enough to figure out. some night I will muck with it a little. I am sure if I lower the memory timings and pump up the volts I can get a bench at 2800.

Might try 2700 with the 5.12's tonight to try and hit 10250.