Bigtoe I just found out on another forum that dfi is not going to fix the issue with using higher than 113% on the nf4 boards. Do you know what caused the problem? If so is there any way that you can fix the issue?
UPDATE.
I found what the issue is and I was hoping you might be able to fix it since dfi is not going to and with my x2 this bios is only one that runs good with my system. The problem is stated here in post 32:
http://www.dfi-street.com/forum/show...=wrong+voltage
"The bug of 7/04 bios is this bios will program "CPU VID Special Control" first
before setting protection to cpu voltage ...
If you set "CPU VID" to a high voltage , EX : 1.55V then change to a low " CPU
VID " and a high " CPU VID Special Control " in the same time , hit the save and exit ...
Before the bios set the " CPU VID " to low voltage , the "CPU VID Special Control"
will be programmed first without protection and may generate some core voltage
like 1.55V * 1.36... Although it's a very short period , but If the cpu can not
handle this voltage , the cpu will be dead ... Especially 90nm core cpu ..."
Reply With Quote
Bookmarks