Abit IP35 Pro - VMod needed

[OC4/3]

Have you lost the components? They should be soldered back to the board or else the circuit is not functioning.

If they are resistors I could measure them if you give me a picture which shows the missing parts positions. I cant measure capacitors at the moment.

Think i had lost the component
The component is as per Jonny Bravo Vdroop Mod Point(The two pieces marked with red dot)

[Spacehead]

Think i had lost the component
The component is as per Jonny Bravo Vdroop Mod Point(The two pieces marked with red dot)

I checked again and noticed that the resistor values are different in Abit IP35 and IP35-Pro. I have the IP35.

[MikalCarbine]

I haven't fiddled with my board in years but I'm getting back into it. All of the pictures in this thread are gone, does anyone still have reference to the working vmods and measurement points (including vdimm)?

[Nosfer@tu]

I haven't fiddled with my board in years but I'm getting back into it. All of the pictures in this thread are gone, does anyone still have reference to the working vmods and measurement points (including vdimm)?

I knew this would happen, so I invested some time in backing them up when I owned OCTeamDenmark.
http://www.octeamdenmark.com/forums/...droop-mod.html

Have fun
BTW I did this for alot of mods, so you can find more old mods in the english section.

EDIT: Some settings that migth be usefull for you
http://www.octeamdenmark.com/forums/...ro-dryice.html

[MikalCarbine]

Thanks much!