EP45-DQ6 vdroop mod...

[Prodigys]

Hello,

Is this mod already been done ?

If not I maybe want to try it, only making macro's with my digi cam is difficult hehe... But i will try if needed...

Greets

[c1rcu1tburn3r]

Post a macro of the zone if u can...

[ceemic]

Sorry bumpin' old thread.
20k VR between FB and VDIFF: http://ceemic.pri.ee/hardware/ep45-dq6/ep45-dq6_02.jpg
http://ceemic.pri.ee/hardware/ep45-dq6/

I even would recommend 10k VR for Vdroop mod and 200k VR for Vcore mod.

[Jor3lBR]

Sorry bumpin' old thread.
20k VR between FB and VDIFF: http://ceemic.pri.ee/hardware/ep45-dq6/ep45-dq6_02.jpg
http://ceemic.pri.ee/hardware/ep45-dq6/

I even would recommend 10k VR for Vdroop mod and 200k VR for Vcore mod.

Hi ceemic do you know if this will work on the EP45_Extreme DDR2? Or there is any for this board?

[ceemic]

Jor3lBR, what IC it has? Do a macro-pic from that area.

[Jor3lBR]

Jor3lBR, what IC it has? Do a macro-pic from that area.

ISL6336
CRZ
F0814BFZC

[Sparda]

Jor3lBR,
http://www.xtremesystems.org/Forums/...=192261&page=9

hicookie said set to 1.5k-1.8k. I set around 1.2k on my quad.

ceemic what value did you use on the poti ?

[Jor3lBR]

Jor3lBR,
http://www.xtremesystems.org/Forums/...=192261&page=9

hicookie said set to 1.5k-1.8k. I set around 1.2k on my quad.

ceemic what value did you use on the poti ?

Thanks Sparda!

So from the original reading of 45.5k I should only get 1.2-1.5k on the DMM?

[Sparda]

Thanks Sparda!

So from the original reading of 45.5k I should only get 1.2-1.5k on the DMM?

afaik when you solder them then the value will droop to around 1.5k-2k(already forgot the value) probably because it connected parellel to other resistor.
Then you set them from there.