How did they do this?

**danstar25** · 04-08-2006, 10:41 AM

http://www.pugetsystems.com/liquid_custom.php

I like the way they have the mesh in the top of the caqse, but anyone know how they got it up there? no screws out the top of the case.

**Badong** · 04-08-2006, 10:43 AM

Did what?

**creidiki** · 04-08-2006, 10:48 AM

The TJ-07 has that mesh as stock.

**danstar25** · 04-08-2006, 11:12 AM

but how did they get the rad and fans bolted up there w/o cutting holes in the case? I was getting ready to cut 2 120mm holes in the top of my v1200 for fan grills till I seen this. I have some modders mesh and might consider trying this myself if I can figue out how the rad and fans are being held up there.

**Badong** · 04-08-2006, 11:18 AM

Same way the SST got two 120mm fans without cutting the case, using stock grill:

**UnreaL** · 04-08-2006, 12:00 PM

There charging $500 for the case, so thats $300 on case, so by their calculations its a $200 kit? (maze 4, swiftech storm, cheap rad + pump & fittings)

I like the case, its a blatent lian-li rip but mesh looks good and mounting psu like that a very nice idea!

**danstar25** · 04-08-2006, 12:26 PM

what does this bolt to?

**creidiki** · 04-08-2006, 12:29 PM

Hex nuts inset in the case. A lot of my stacker is done like that too. Looks nifty.

**danstar25** · 04-08-2006, 12:41 PM

Ahhh, got it now. Thanks creidiki.

**racinjimy** · 04-08-2006, 12:49 PM

Originally Posted by UnreaL

There charging $500 for the case, so thats $300 on case, so by their calculations its a $200 kit? (maze 4, swiftech storm, cheap rad + pump & fittings)

I like the case, its a blatent lian-li rip but mesh looks good and mounting psu like that a very nice idea!

the case is closer to $400

lian-li rip, not really, more like new and improved