Dtek Uni-sink (Rev 2) SLI Installed With Pictures

[Snyxxx]

Making a 2nd machine, so I dusted off two of my MCW60s and decided to put them to use along with a Storm CPU waterblock.

After getting tired of all the little ram sinks that goes with a MCW60, decided to give the revised Dtek Uni-sink a try. Never had the Rev 1, but the Rev 2 looked a lot better in terms of stiffness and more fins over that hot little naked chip all by itself.

Only the four uni-sink holes need to be drilled out to accept the 2-56 screws from the G80 mounting kit. That is all. The nuts and washers clamp the uni-sink to the board and now puts pressure on the perimeter ram chips which was a criticism of the first uni-sink.

I think the pictures are self explanatory.

http://www.xtremesystems.org/forums/...1&d=1200372598

http://www.xtremesystems.org/forums/...1&d=1200372598

http://www.xtremesystems.org/forums/...1&d=1200372598

http://www.xtremesystems.org/forums/...1&d=1200372598

http://www.xtremesystems.org/forums/...1&d=1200372598