Quote Originally Posted by raju
you need a 40k variable resistor (usually 25 turns), set it to maximum 40k first and work down. First few turns will do nothing, after that it will begin to creep up, you can go to pc health check in bios for a reading, I set up the screen in front of me while I adjust. Or use a dmm and adjust very slowly checking constantly for change, don't overshoot!

I'm a little concerned if you did not know this, only proceed if you're comfortable, otherwise you'll end up with a dead board...

regards
Raja
Raja... do you happen to know what ohms you ended up with at 1.9v ? I don't have any 40k vr's, but a bunch of 20k. If you are ending up with 20k or less at 1.9v I could use one of those, my board will be used for phase and dry ice benching only. Also, do we still need to set all the ram drive strengths with this new bios, or is default ok?