Actual TwinMOS Modules and ICs

[EvolutionCrazy]

HI,Evolutioncrazy;

The ram you pictured, is it the one listed in the block of specs?

The one in the picture is AADT, but unless I am mistaken[probably so] the specs;

M2G9JA8AMK9F081CAD

indicate a CADT ram, yours should appear as a AA4 on the last letters.

Also, what are the numbers etc on the chips? I have CADT that are 50I

If I am incorrect, could someone explain, I am very willing to learn.

mike

i've also noticed that thing... but dunno... (the label show AA4T )

yes... this photo:


and this shoot:


are related to the same stick...

that's another thing that make me suspicious about "bad spd programming"...

i'll take out the stick and post a full quality scan in the next hour

take a look at this pic:


i've never seen CADT doing 230 2228

[mike047]

HI, I just got the CADT chips yesterday and have not used them yet.
I was told on another forum that they were not good chips[50I]. I am going to vmod an Albatron KX18 PRO board this afternoon and then I'll see what they do.

There is a timing difference in the two CPU-Z shots???

[EvolutionCrazy]

There is a timing difference in the two CPU-Z shots???

200mhz 2.5-3-3-8 by spd...

however mine are 50D

this is the chip (date MUST end with 4!):


front:


back:


i cannot explaint the wrong spd detection under windows (wrong type (CAD instead of AA4) and no manufacturing date...)

does the problem is the spd?


i hope someone from twinmos can tell us

[mike047]

HI,
I have 3 sets;
TMSP400;AA4T 44D TWINMOS chip
TMII400;CADT, 50I TWINMOS chip
These two have the same spd chip as yours.

The other set is;
TM333; AADT, 60D MTEC chip
This one has the spd chip[it is also smaller] in the lower right, below where yours is.
These are only 333 but they both will do in excess of 220 with no additional voltage.

I have another TM333 set[1DDT] that run 200, I think they are 60B MTEC. They run 24/7 in a folder.