Intel 4.5GHz & 5GHz LinX Stable Club

[SteveRo]

Good afternoon Mr Zalbard,

Please update my Gulftown entry - I wanted to be the first linx stable 32nm over 5ghz, this is with two stage Cascade cooling.

Same 980x as previous - 3003B287

The lowest evaporator temp was -98, the lowest IHS temp was -57.

I don't think this is the lowest cpuv for this chip @ 5ghz - I did not spend a lot of time adjusting.

I have uncore and memory set very slow.

I have some happy snaps located at - http://www.xtremesystems.org/forums/...d.php?t=255686

Also, I didn't want to put the added stress of HT on the chip though I do think the chip would do 5ghz HT - perhaps even at these same settings.

Anyway - so screen shot -

[OC Nub]

Good afternoon Mr Zalbard,

Please update my Gulftown entry - I wanted to be the first 32nm over 5ghz, this is with two stage Cascade cooling.

Same 980x as previous - 3003B287

The lowest evaporator temp was -98, the lowest IHS temp was -57.

I don't think this is the lowest cpuv for this chip @ 5ghz - I did not spend a lot of time adjusting.

I have uncore and memory set very slow.

I have some happy snaps located at - http://www.xtremesystems.org/forums/...d.php?t=255686

Also, I didn't want to put the added stress of HT on the chip though I do think the chip would do 5ghz HT - perhaps even at these same settings.

Anyway - so screen shot -

Congrats!!!!! Thats pretty awesome, nice work.

[SteveRo]

Congrats!!!!! Thats pretty awesome, nice work.

Thanks! I have a better mount now
I scrapped some of the eraiser off the top of the cpu bracket to get a little better contact.
Temps are even lower now - IHS no load is -87/88C

[xpatar]

980x (6C/12T) @ 4530 MHz - Vcore @ 1.44375v - Gigabyte GA-EX58-UD4P (rev. 1.0), bios version F13 - water - 3003B320