Today I got to leak test stage - did 3 times and fail each time.

Now what are your guesses? I hear now "must be one of those gazzilion rotaries in there!"

Well, no. Each time Liquid Fusion res failed.
1st - bottom inlet
2nd - bottom inlet again (this time I've used plenty of thread sealer tape)
3rd - inlet fine but - water came out of the cavity between acrylic & alu.

So I'm very dissappointed with this product - it was suppose to be one of the highlights of this build.
This res turned out to be piece of junk - very pretty - but still piece of junk.
(I know there were revisions going lately but this doesn't help all those who got faulty ones.)

Small rant over
Time for plan B - EK multioption res. Pays off to have spares lol

Lessons learned today:
1) There is no "too much" with paper towel
2) If you think you've drained the loop....well, there's still water there
3) If you just got remaining water on your pants from parts where "there was no water"... well, there's still water somewhere



Here are some pics from yesterday today so you can have an idea how it looks now: