If I run single channel (1 stick) I can pass 8 hours of Orthos @ 300x10 1200MHz Mem DDR speed. That takes 1.5125 volts to the proc to get the memory controller to handle it though.

The setting below is also 8 hours Orthos stable (8 is good enough for me) and it also requires 1.5+ volts to the processor (Normally takes 1.3~1.35) to get it stable in dual channel @ 280x10 932MHZ DDR Speed.

Not bad for a AMD Box. The Memory is PC9600 Flex - I've only had 1 day to play with it. So perhaps I can do better with more playing. The limiting factor right now is the lack of CPU volts available. Since I'm running water I can give this little Operton alot of juice - Which it really wants when you start overclocking the onboard memory controller. I can run 1.5625 (Max Vcore for an Asus M2N32 SLI Deluxe Wifi) I temps barely sip @ 60C. Which ain't bad at all considering how much overvolting that is. If I can find a way to volt mod this baby I'm sure I could take a shot at this club :-).

P.S. Does anyone has a good Alpha Timing Table or something that you could post so I can see what the Alpha timings for the Flex 1200 are supposed to be. I don't think my board is detecting them correctly (Especially tRC @ 19!?!) - If anyone could post up a MemSet3.4 or 3. whatever screenie that would be great.

Sorry for hijacking the thread. Congrats to all you who made it.

See Ya,
Jealous AMD-Fanboy

Kidding! About the Fanboy part anyway.. I'm just poor.