Spring break upcoming!

[n00b 0f l337]

Time for some contributions...

Some new welding magnets, big 150mm, with 35 kg of holding force

A small pile of Tes2's...

Nice part off tool, solid carbide.

Twelve hockey pucks...?

Timing belt for the belt conversion on the milling machine.

R8 tapered 3 jaw chuck... evaporator lathe work on the mill!

A surprise!
R23... 20 lbs!

And my lovely girlfriend drew this up as a birthday present for my apartment.

[n00b 0f l337]

Fun in the sun, look what just showed!

[runmc]

Let's see some copper fly Adam!!

[n00b 0f l337]

I'll be home in less than a week Then we'll see how the parting tool and such mounts and does on copper, or if I go for more of an eleven style evap (very hard to do without a rotary table sadly).

[ZenEffect]

hey what size rounds do you need for evap? ive got a 2.5x11 bright copper round collecting dust.

[n00b 0f l337]

I have 1.5" and 2.5", if your looking to sell the 2.5" though, drop me a PM.

[n00b 0f l337]

Some other arrivals.
Mill should be pretty good to go when I show up.

[wdrzal]

Did you get a Mill Noob?????? Looks like some tooling for one above.

[n00b 0f l337]

I've had a mill for a few years. A Sieg X2, its not that great, but with a motor upgrade, switching to a belt drive, and properly aligning the gibs and solidfying it, it's taken up a bit of actual life.
I'm just getting around to spending the $$$ to buy really good tooling for it so that I can upgrade to a better mill and still be functional.

Spend well once, never have to do it again I guess.
Didn't do that with the mill.

[piotres]

Nice tools and parts Noob !