Aeigis (sp) panel for Win 7????

**scgt1** · 09-30-2010, 05:27 AM

So I installed an ssd yesterday and I'm reloading the computer today. Well nice files on the cd don't work for win 7 as I knew from before, but I though the Aeigis panel app worked from the disk. Apparently not, considering it states unknown operating system.

I can't find it on Foxconn's website which let me tell you sucks since it took forever to get the drivers due to traffic or something going on their yesterday.

Funny thing is the Flash app worked off the disk. Says I have the most current P09 bios. I doubt that since I think Foxconn's website said there was a p10.

The bios thread here on the forums is outdated and a cluster. So anyone know what the best most stable bios is for benching and daily use? As well where to get it? And of course the Aegis panel software for win 7 x64.

**rioja** · 09-30-2010, 09:11 AM

i downloaded aegis somewhere from this forum but don't remember exactly which thread from
if u will search it carefully u'll find it for sure

**Mescalamba** · 09-30-2010, 10:56 AM

Its near useless and SetFSB works. If you set voltages high enough, you can "push" it via SetFSB.

And anyway, theres no use for that unless you plan to break some record..

**GunGod** · 10-14-2010, 10:26 AM

Catch ... v.2.12.54

Link will last till 28.10.10 so if u need it later msg me

Have Fun!

**Mescalamba** · 10-14-2010, 01:06 PM

You made something bit wrong, cause it downloads as .htm file. Though simple renaming to .rar works.

Thanks for upload, I downloaded it, so if anyone will need, I will have it.

Unless my HDD dies or so..

**GunGod** · 10-14-2010, 02:27 PM

works as Rar here check your settings

**homefry** · 10-14-2010, 02:39 PM

Does this let you adjust 3 pin fans as low as 20% power?

Because I know through the mobo bios, that 62% is the lowest you can go. I mean you can adjust it to 20% and it works in the bios, but as soon as you save and exit, the fan goes back up to 62%.