Stepper rev. 2#

[bartx]

I'd like to show second rev. of my stepper evap. Design is basically the same, but I've made a few improvements:

- feeding from the top -> refrigerant is going back through the center of the evap (there is a hole with thread to make bigger surface)
- base is about two times thicker
- diameter of the base if a bit bigger than diameter of the pipe -> brazing will be much easier
- evap is 8mm taller and heavier than a previous one



Here is the link to previous revision:
http://www.xtremesystems.org/forums/...25352-New-evap

[sdumper]

I like looks very clean

[piotres]

Nice ! When we'll see a complete unit with this evap ?

[bartx]

Here is brazed evap. As you can see, brazing is much easier now