Ok, this may seem a rather stupid/odd question... but how much sleeving do you use to sleeve a power supply and all its cables?
I've done a bit of sleeving on my PSU and think I am going to re-sleeve it. I didn't want to sleeve each cable seperately, but I dont like the way it looks sleeved the way it is at present. So I was thinking of re-sleeving each wire individually. The way it seems most are doing it now.
How much sleeving is used? I did some basic measurements, and either I am really tired and just not adding right, or my numbers are
way off.
To sleeve each wire individually, how much sleeving is needed?
I have access to 3mm (1/8"), 6mm (1/4"), 12mm (1/2") and 18mm (3/4") sleeving.
From what I can tell, a single wire sleeve will be the 3mm (1/8").
The sata cable sleeve I'm unsure of, but can tell I will more than likely use 12mm (1/2") heatshrink and 12mm (1/2") sleeving for those. Doesn't look like the next smaller size will fit.
![I don't know](http://www.xtremesystems.org/forums/images/smilies/shrug.gif)
Unless someone knows of the right size?
Thanks for any input.
Bookmarks