spi1m @ 22.453s It froze after the run so I had to take a picture. It's on a friend's camera, I'll try to get it today;)
I was very close to the coldbug limit, so I don't think I can push it too much more. It didn't like more volts either, but I'll try it more later. Need to get some 32m runs etc first (hwboints, you know;) ). It was very hot, idle to laod difference was more than 20c! I guess I have to remove the ihs to get lower load temps.
I got it fro mebay a while ago, stepping is CAB1E 0622FPMW.
When I bench I don't bench 100% outside, I bench in the garage, so even if it's -5c outside in the middle of the night, it's not below 0 where the pc is. But does it matter that much? I mean, because of the neoprene, the ambient temp shouldn't change the pot temp.