Printable View
I agree...
RAID 0 on the Marvell Runs slower than a single drive... I'm Running the same thing as above poster... 2 Crucial Nova 128's in 0 on the Intel, and a Single OWC 240gb Drive w/Sandforce controller on the Marvell, and I'm getting really good speed.
Best,
Roydrage
http://www.snackstuff.com/drivebenchmark.jpg
Thanks fmsam & RoydRage for your input.
Do you think I will be better off just getting a C300 128GB version as my win7 drive and having the 64GB version for a few extra games.
No more Bios updates ? >_<
If you plan on using more than one C300, do yourself a favour and grab an LSI 9211-4i HBA as well. C300's used on ICH10R is crippling their performance. And the Marvel 6Gbps controller can not handle more than a single drive.Quote:
Originally Posted by Piggin
You mean a Crucial Drive Right? The only Sata III ssd out right now?Quote:
Originally Posted by Piggin
I would forget about those right now... The Write speeds suck Ass... 140mb?
Writing is just as important your better off getting a Force Series Corsair or similar... I have an OWC and Muskin makes a nice Drive that also uses the Sandforce controller.... OCZ does but I always found their products very inconsistant... I and used there stuff 10 years ago.
If you use the samsung or any of the Inilinix controllers you will run into severe slowdowns from Block contamination. The sandforce controllers have a block leveling feature... OWC calls it Durawrite that tidys up after itself.
It's better to put your Boot drive on the largest partition you can, and it won't slow down so fast cause it will always have a new place to write where blocks don't have any fragments left in them... It also increases the life of the drive as you arent erasing blocks needlessly.
I have 2X128gb RAID 0 for my Boot drive, and only have 70 of the 256gb used... That is good. And I use the OWC 240gb drive for my Games and Photoshop Sratch disk... Also I burn an ISO image of the games disk, and mount it using virtual clone drive... This way the game starts up Super fast, and I don't need a disk to play it... *Note you will need to install the game from this image/Virtual Drive.
I also have a 1TB WD Black Caviar for Archieve storage, and I keep my paging file on it as well... Since it's on a different controller, it really stops interference with your read writes, and saves wear on the SDD's as well!:up:
Best,
Royd RAGE
124 and 101 is usually Vcore.Quote:
Originally Posted by Dom7184
Wellll. high density chips are not at their peak now.. I think your best bet is to just pick out 2 3x2gb kits at 2000. I like the corsair ones, but without a 980x with the 1.5x uncore multiplier, you're going to be having some really hard times with QPI voltage.Quote:
Originally Posted by nightwoodwolf
I have had my R3E for quite some time now and im very happy, atleast after i updated the bios to 1102 :D
Now to my question, im thinking about getting a 3rd GTX470 and run a tri way sli setup.
Is my Coolermaster Silent Pro M1000 enough to run 3 GTX470 and a i7 930 overclocked to 4.2GHz (21x200 1.4V).
Second of all, the manual says to use slot 1,3,4 for tri way, but the bridge they added in the motherboard package suggests 1,2,3, any thoughts around this?
If the PSU i have aint enough, what should i go with? AX1200 seems to have alot of issues still even though some have been fixed in later batches.
lowfat & RoydRage
Thank you both very much for taking the time to help me.
I now think it could be a change of direction for me & go with Raid0 using OCZ Vertex 2E 120GB drives on SATA2.
I have a problem with my config, I have the computer freeze, often
I tested the OC with HyperPI 32M, LinX, OCCT, etc... is good (@stock is the same, while AUTO in the bios)
I tested the SSD Intel X25-E with the Intel Toolbox, no problem
what I could try to find the problem?
freeze it at any time, in IE, FF, Windows, etc. ...
bios 0011 and I feel that it may come long after the shift to 970 and ram @2000 (Dominator GT 2000 C7), I had a 920 before and the same ram but @1600
thanks ;)
I quote! :mad:Quote:
Originally Posted by AceBaran
Last official BIOS is 1005 of two months ago.
1102 is newest @ the moment
...but not official. :)Quote:
Originally Posted by Fire4Wire
i telephoned with asus germany the last 5 mins and they told me that 1102 is an alpha not an beta and it tooks a longer time for the next stable release bios
great..............
No more Asus BIOS engineers? Everyone ill, fired or in strike? :mad:Quote:
Originally Posted by Fire4Wire
Sorry for sounding dumb but what is the difference between alpha and beta and which one is a stabler release?Quote:
Originally Posted by Fire4Wire
Thanks for responding.
Alpha -> Beta -> Release Candidate -> Final ReleaseQuote:
Originally Posted by Sylver123
this is an internal bios changlog there you can see there are some days without working on bios see the right site
RampageIII-Extreme-ASUS-1102.ROM (HW:01h BB:45h EC:xx VGA:xx) 2010/09/23
================================================== =====================================
Bytes Reserved : F2000 Bytes Used : FC078 Bytes Free : 11F88 Checksum: 6610
PCB Version: 1.04GT
EC1 FW:60
EC2 FW:14
EC3 FW:09
RC Version: p2.70
OC Station configuration table version: 0007
================================================== =====================================
1. Updated CPU micro code(s):
* M03206C2_00000013: Gulftown i7-980X B-1.
************************************************** *************************************
RampageIII-Extreme-ASUS-1101.ROM (HW:01h BB:44h EC:xx VGA:xx) 2010/09/13
================================================== =====================================
Bytes Reserved : F2000 Bytes Used : FC074 Bytes Free : 11F8C Checksum: C128
PCB Version: 1.04GT
EC1 FW:60
EC2 FW:14
EC3 FW:09
RC Version: p2.70
OC Station configuration table version: 0007
================================================== =====================================
1. [E.E]Patch cpu temperature may display 0 degree issue by HW request.
************************************************** *************************************
RampageIII-Extreme-ASUS-1005.ROM (HW:01h BB:43h EC:xx VGA:xx) 2010/08/26
================================================== =====================================
Bytes Reserved : F2000 Bytes Used : FBFF8 Bytes Free : 12008 Checksum: E555
PCB Version: 1.04GT
EC1 FW:56
EC2 FW:13
EC3 FW:09
RC Version: p2.70
OC Station configuration table version: 0007
================================================== =====================================
1. [E.E]Removed XPANDER firmware update function.
2. [E.E]Updated EC1 firmware version form 56 to 60.
-Fixed CPU voltage incorrect issue, if user OC station and ROG connect.
[E-Service No: 4285211]
-Modified SMBUS interrupt function.
3. [E.E]Updated EC2 firmware version form 13to 14.
-Modified SMBUS interrupt function.
4. Fix some character not correct, if languages is set to japanese in BIOS setup menu.
[E-Service No: 4302070]
************************************************** *************************************
RampageIII-Extreme-ASUS-1004.ROM (HW:01h BB:43h EC:xx VGA:xx) 2010/08/05
================================================== =====================================
Bytes Reserved : F2000 Bytes Used : FE058 Bytes Free : FFA8 Checksum: F5D1
PCB Version: 1.04GT
EC1 FW:56
EC2 FW:13
EC3 FW:09
RC Version: p2.70
OC Station configuration table version: 0007
================================================== =====================================
1. [E.E]Supported ROG XPANDER by HW request.
Changing out my old Motherboard for a R3E produced these results with my Vertex SSD's (on an LSI controller)
The best I could ever reach with an old nvidia based motherboard
http://db.tt/4UluWbG
New R3E board with same windows install
http://db.tt/y3KylxW
I can't imagine the results upgrading to 120GB vertex's would bring !
Meanwhile, Boy am I happy :)
R3E Rocks!!
Had no problem booting to this. But it seems that my keyboard and mouse intermittently dropping out. Can't say I've ever had an problem with an overclock like that. Hell it even ran a few minutes of folding@home and did not crash.
http://img820.imageshack.us/img820/5936/capturemv.jpg
When experiencing a freeze the first thing I check is the memory http://www.memtest.org/ then video card (swap it out for another old card), also your SSD may be an issue (try using a HDD for a while)Quote:
Originally Posted by tistou77
more PCI-E remedied the stutter for me :)Quote:
Originally Posted by lowfat
I'll give that a shot, but if I remember correctly my ioXtreme drops out @ 107MHz :down:Quote:
Originally Posted by Splave
I just installed my REIII last night with a new i7 930 and no matter if I am running stock or overclocked, Vcore is blank in CPUZ.
Anyone have this problem or know why it's happening?
Still can't figure out why vcore doesn't show in CPUZ.
Just got everything put together last night and had some time today to play. Was able to get 4.2Ghz 21x200 and 4.4Ghz 21x210 LinX 5 runs stable but wanted to see how far I could push this new 930.
Core i7 930 Batch# 3019A730
REIII Bios 1005
Kingston HyperX 3x2GB DDR3-2000 CL8 w/KHX Fan
XFX HD5870 XXX Edition
Corsair TX850 PSU
WD Caviar Black 2TB
ApogeeXT~ek 360 Rad~D5~1/2"ID x 3/4"OD
http://i580.photobucket.com/albums/s...I_1M_8799s.jpg
http://i580.photobucket.com/albums/s...e32M_5462s.jpg
http://i580.photobucket.com/albums/s...tageP22757.jpg