?? Vmods for ASUS P4P800-X ??

[persivore]

For the Vdroop mod, connect a 100k variable resistor between the two points I've marked. Before modding, check that the point I've labeled reads Vcore. Decrease resistance until there is only a small amount of droop.

[Kjaups]

do i need to measure these 3 pints what u marked out or only that chip leg???
what happens if i decrease resistance too much? to any mosfets heat up with that???
Have any pencil mod for that?

[persivore]

check the voltage at the point where there is space for a capacitor to be soldered circle with half of it coloured white.
I can't follow the traces on the picture, so its a bit hard to work out any pencil mods
If you decrease resistance too much, you could damage the Vcore capacitors and MOSFETs. Vcore will probably be decreased slightly by the mod.

[hendrasystemind]

mr Kjaups can i know what memory do u used

[Kjaups]

mr Kjaups can i know what memory do u used

U said in msn that u have done VDIMM mod for that motherboard.
Can u give my pictures of it?

PQI ram with PQI chips on it.

[hendrasystemind]

i mod my mobo by connect the yellow pin to the ground with 50K.
any suggestion for the VCORE mod.
for mr Kjaups can i know your RIG, THX

[Kjaups]

i mod my mobo by connect the yellow pin to the ground with 50K.
any suggestion for the VCORE mod.
for mr Kjaups can i know your RIG, THX

Thanx, now i will find some stuff and start to mod .
Some juice for rams

[Kjaups]

i mod my mobo by connect the yellow pin to the ground with 50K.
any suggestion for the VCORE mod.
for mr Kjaups can i know your RIG, THX

I hope u can read this soon.
Im planning to mod today, i have everything for moding, but i need to know, where did u measured VDIMM voltage????

[Kjaups]

@ hendrasystemind

Are u sure that u connected 50k with pin 2 ???
My motherboard stoped responding for 10 minutes with that mod :S ....
I hope, that nothing serious hapened.

Can u give me some picturs of your mod

[hendrasystemind]

sorry, i uploaded a wrong picture
btw do u check u soldering, any short component ?
connect the pin no 6 with a 50K to the ground.
please check the lm 324 datasheet. i think is pin no 6
here is my mod pic. (dont have a camera right now )

[Chillerzero]

what is the status now on a good Vcore Vmod ?

[sin0822]

This is from my p4p800-se the first is the vdroop with the solder on the chip its to a 100k pot, i think its the p4p800 se i was so proud i took a pic, it was my first vmod.