Originally posted by sandman Thanks Jeff, looks like a winner.
What range of temps does it measure? been happy with it so far?
Yes, I'm very happy with it. I've measured -10f to 70f and the temperatures have been accurate so far. For $30 I don't have a single negative thing to say about it.
BTW, battery life is not what I'm used to. So far this 9v battery has been left on for days on end a couple times and it hasn't pooped out. My old RS pocket DMM would have only lasted through one of these sessions before needing it's button battery replaced.
As others suggested, unless you have money to burn, go over to Radio Shack, spend around $30.00, you'll have a long lasting tool that will be plenty good for any Voltage measurements you'll need to make. Yes Fluke makes quality, however no reason to pay for that quality for your intended purposes.
I got the pocket one, its pretty good. It auto adjusts so it takes all the fun out.
__________________
Quote:
And it's whispered that soon, if we all call the tune
Then the piper will lead us to reason
And a new day will dawn for those who stand long
And the forest will echo with laughter
And it makes me wonder
If there's a bustle in your hedgerow
Don't be alarmed now
It's just a spring clean for the May Queen
Yes there are two paths you can go by
but in the long run
There's still time to change the road you're on
see I can't agree with buying the cheapest. I had a $5 special one from AutoZone and used it for a while. Well, I got the new one I linked to above and it's voltage reading are almost .05 lower than the crap one on the vgpu of my 9800pro. I confirmed this with other readings too. Now with some vmods .05 could spell disaster.
Therefore while $30 is by far not a lot of money it is a lot better to spend that than $5. I think there is a lot bigger difference between the $30 and the $5 than the $30 and say a $100 Fluke.
I just got a used Fluke 12b in good shape for 25 bucks.
Question: it has a sticker on it from Bosch, that says "calibration" and a bar code. What exactly does that denote?
Also, how can I check it to make sure its giving accurate reading. I got Fluke's service manual for it, but you have to have their test equipment to test it.
Thanks
__________________
"I won't predict where we will end up" - Geforce4ti4200
Originally posted by nailbomb I just got a used Fluke 12b in good shape for 25 bucks.
Question: it has a sticker on it from Bosch, that says "calibration" and a bar code. What exactly does that denote?
Also, how can I check it to make sure its giving accurate reading. I got Fluke's service manual for it, but you have to have their test equipment to test it.
Thanks
Decent deal, some electronics repair require you have your measurement equipment officially calibrated, one such instance is in the repair of Government communications equipment. The bar coding probably has info encoded about when, where, and by whom the last calibration was made.
The easiest way to check accuracy is to measure some known quanities, or to compare it with other measurement devices. barring that sending it to Fluke, or another service center. If I had no other resources to check relative accuracy perhaps a trip to a local TV /electronics repair shop would do, they should be willing to check it out for little or nothing.
Originally posted by joni Could you give an example?
I don't even know what "quanities" means! , my English-Portuguese dictionary don't have that word!
I guess a good place to start would be to Check your Computers PSU voltages, read with your multimeter, and compare to readings given by on-board monitors through monitoring software such as Motherboard Monitor. This obviously is not 100% accurate, as it relies on unknown values. However it will give you a relative idea. To be certain it would be best to have aonther DMM to compare it with, or as I stated, visit a local Electronic repair center.