Pi1m dual channel
Team group 1066
Pi1m single channel Crucial 6400
max fsb 657MHz
Crucial
well the Crucial is not holding me back cz Team does the same
6300MHz
CPU - E8600 Q820A599
MB - Bisotar TP45 HP rev 5.0 (no mods) + Tpower i45 heatsink + SanAce F6-PWM 60mm 23CFM(4600rpm)
Bios - 0710
RAM - Crucial 6400 - Team 1066 + Scythe Kamakaze2 92mm 73CFM(3800rpm)
VGA - HD4870X2
HDD - Hitachi 40gb ata 7200
PSU - Giga-EZ 1000w
Over-Clocking Navigator - Manual
Intel SpeedStep - Disabled
Ratio CMOS Setting - ×6 - x10
CPU Frequency Setting : 620 (team for fsb) ,600 (crucial for fsb) , 580 (for clock)
Over Clock Retry Count : 1
FSB(Bsel) To NorthBridge Latch : 1333
DDR2 Enhance Mode : Disabled
************************************************** ***********
DRAM Timing Configuration
DDR2 RCOMP Configuration : Configuration 2
Static tREAD Value : 13
Configure DRAM Timing by SPD : Enabled 5-6-6-18-6-42-5-5-5
************************************************** ***********
Clock Gen Configuration
PCIE Frequency Setting : 100
CPU Clock Skew Control : 200ps
(G)MCH Clock Skew Control : Auto
CPU Clock Driving Control : Auto
************************************************** ***********
Voltage Configuration
CPU Voltage : +0.1 for fsb and max for clockin
DDR Voltage : +0.700v - 0.800v
Chipset Voltage : +0.700v
FSB Voltage : +0.3500v
CPU Core1 GTL Ref Voltage : 0.63*VTT
CPU Core2 GTL Ref Voltage : 0.67*VTT
MCH GTL Ref Voltage : Auto
CPU PLL Voltage : 1.6v - 1.7v
Bookmarks