Over the course of the last two weeks, i've had a motherboard die, lost a raid array and borked the firmware on my Mach II GT controller.
(Getting the "Boot Loading Waiting" message)
To reinstall the firmware, i need to install the software. After some difficulty, and installing Vista 32bit (as the drivers are not recognized in 64 bit) i was able to get the drivers to take, and the software installed.
(Note: this means in device manager i have the proper identification of the unit)
Now when i try to run MCC (the Control Center software) i get the message: "USB Error" and "USB connection failed -unable to run program" I have tried reinstalling the software, this proved futile.
Any suggestions are welcome
Thanks
TLD
Bookmarks