Hi all
Need some help planning my loop.
Here is the layout of the case
Would like to keep tubes short and good looking.
My initial plan was:
Water goes from the pump to the top of the rad inlet, then to CPU block, then MB Northbridge block, then to the reservoir side inlet, then to GPU and back to the pump.
Most likely GPU will be 2 slots lower than in the picture, reservoir can be placed anywhere - didn't drilled anything for it yet.
Pump can be turned and mounted to rad fan using UN Designs Z bracket.
In the picture rad is placed with inlet/outlet in the upper side, but can be turned upside down.
Preferred order is CPU right after the radiator, but if another order doesn't have any noticeable defference in CPU temps - it is fine.
Also I have
this thing as a drain port it should be placed somewhere in the bottom too.
That's it. Thanks in advance, any advices are highly appreciated
Linear Mode
