need some advice on W.C looping

heatkiller · 11-05-2009, 07:49 PM

hi all W.Cer would like to know if i can run this loop ???

Ek res +355 pumpX2 with dualtop > Fesser 360> Fesser 240> Cpu block> >nb/sb> Quad gtx 295

All in one single loop. Rads will be push & pull by S-flex-Fs

will it be fine with this loop???

need some proS advice

thx!

Caoder · 11-05-2009, 08:12 PM

4 x gtx 295?... flow won't be a prob but temps just might be a bit much for the rads you have for it. and the cpu temp won't be as low as you would prolly like it to be. i assume you have an i7 as well.. normally just for the i7 oced is a tripple and if you have 4x 295s i would say that would need a quad for itself.

heatkiller · 11-05-2009, 08:14 PM

Quote:

Originally Posted by Caoder

4 x gtx 295?... flow won't be a prob but temps just might be a bit much for the rads you have for it. and the cpu temp won't be as low as you would prolly like it to be. i assume you have an i7 as well.. normally just for the i7 oced is a tripple and if you have 4x 295s i would say that would need a quad for itself.

bro 2 pcs sli 295 + 920 i7 i using

Hondacity · 11-05-2009, 08:21 PM

two rads and push pull....you'll have better temps than aircooled

heatkiller · 11-05-2009, 09:08 PM

Quote:

Originally Posted by Hondacity

two rads and push pull....you'll have better temps than aircooled

so will it be good? in 1 single looping with all items....

maybe i go for 2 way manifold for tubing...
one way with cpu+ns/nb the other with gpu's only
i think sure be better maybe...

millertime359 · 11-06-2009, 06:20 AM

Quote:

Originally Posted by heatkiller

so will it be good? in 1 single looping with all items....

maybe i go for 2 way manifold for tubing...
one way with cpu+ns/nb the other with gpu's only
i think sure be better maybe...

If you want to do that, then just get this and run dual loops.

It should be fine seeing you have the push/pull fans though.

heatkiller · 11-06-2009, 07:34 AM

i using dual top for both 355's

no place for tat xspc bay type....

millertime359 · 11-06-2009, 07:56 AM

Quote:

Originally Posted by heatkiller

i using dual top for both 355's

no place for tat xspc bay type....

I know you are using the dual top. I was referring to the manifold you want to set up. If you want to try splitting the loops, might as well just do dual loops and you shouldn't have to worry at all then.

You don't have 2 open 5 1/4" bays then?

You should be fine with just the one big loop though.

heatkiller · 11-06-2009, 04:29 PM

thx Millertime^^