What loop would be best?

Barso · 09-25-2009, 12:10 PM

I have purchased a block for the chipset of my classified and already have a heatkiller 3.0 on the cpu.
I currently have: RES-CPU-RAD-RES but would I be better with in the new setup:
RES-RAD-CPU-CHIPSET-RES or RES-CPU-CHIPSET-RAD-RES ?
Thanks for all help and replies.

Caoder · 09-25-2009, 12:14 PM

doesn't matter.. whatever looks best

cky2k6 · 09-25-2009, 12:16 PM

I'm assuming your res is a res/pump combo? its always better to have the rad immediately before the cpu, not a huge difference, but no reason not to unless its easier with the tubing.

millertime359 · 09-25-2009, 12:28 PM

As long as res is before pump, doesn't matter

Barso · 09-25-2009, 12:35 PM

Thanks for the help.
Yes, it is a combo.
I will rad after res then.
I was contemplating swapping my rad around as it sits at the top of my cosmos s in the case and if I swapped it around 180 degrees the inlet/outlet would be closer to the res that is in the drives bays at the front.
Also if the rad leaked at the inlet/outlet it would not drip onto my GPU.
Thanks Miller, you're always here answering my questions.
Thanks to evreryone else too.
Now just to sort the bloody stuttering problem I have with my GTX295.