Compact Gpu Ss

Duniek · 09-22-2006, 11:23 AM

hello
this is my next unit for gpu (that unit will be cooling a radeon 1800 or 1900xt)
parts:
compressor is a unitad hermtiqua/elektrolux/acc GL90TB 1/3hp
homemade condenser with 12cm NIDEC @ 6V

evap

I saw a -44*C but I don't have a photo :|
btw my thermometer is very very bad
http://img60.imageshack.us/img60/258/termo1ug3.jpg

regards

DeNs · 09-22-2006, 05:13 PM

Very nice

However if you were to use it in a case, wouldn't the suction line be a little long? If you curled it around a little like the 3rd pic and mounted it I'd think that it'd put force on the card to pull it sideways out of the slot!

For benching it'd be fine, just It looks a little awkward for case mounting.

---dens

Duniek · 09-23-2006, 04:47 AM

Quote:

Very nice However if you were to use it in a case, wouldn't the suction line be a little long? If you curled it around a little like the 3rd pic and mounted it I'd think that it'd put force on the card to pull it sideways out of the slot!

For benching it'd be fine, just It looks a little awkward for case mounting.

---dens

I made this units for a friend (COMPACT CPU + GPU SS)
suction line is long (65cm) because GPU ss will be stay a near a my another unit (compact ss) and CPU unit is stay under computer case

http://img141.imageshack.us/img141/4481/1cq8.png

DeNs · 09-23-2006, 05:29 AM

Ahh ok understood

Looks to be a very nice setup then. Will you have any results before it gets sent off?

---dens