Results 1 to 25 of 357

Thread: Official Gigabyte X48/X48T-DQ6 bios+info thread

Threaded View

  1. #25
    Registered User
    Join Date
    Apr 2008
    Location
    Up State New York
    Posts
    94
    Quote Originally Posted by Sanad View Post
    i am having trouble gettin to 3.4ghz with my quad! My multiplier is 9x and my fsb set to 376. The voltage is first set to manual at 1.325 and then auto. Computer never boots and everytime board switches back to auto and resets to 2.4ghz. All overvoltage controls were set to normal when i adjusted manually and graphics booster to auto. Same auto for ram. I am running two Corsair dominators 1066 2 x 1gb.
    Are you adjusting the memory multi so that it will run @ or near native clocks? It will reset back to no over clock if the over clock failed. While trying this only adjust one setting at a time so as to know what is causing the problem.

    Also make sure the DDR voltage is set properly for those sticks as this may be the cause of the failure to begin with.

    Any body try the F8a Bios update yet for the X48 DQ6?
    Ok, I finally over clocked on this bios and as it has been sometime sense I used the board it seems stable. I will report back with more sooner this time too
    Last edited by jaggerwild; 12-04-2008 at 01:17 PM.
    RIVE/3930K Water
    16GB Gskill Ripjaw X 2133
    2X Intel CherryVille 520 60GB Raid O
    2X HD 7970 VisionTec
    Corsair AX1200

    Biostar TP45HP, GA-X48-DQ6 , Maximus IV Gene Z

Bookmarks

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •