It is true what Pazza316 say, its quite hard to insulate that setup mostly due to Flexline all the way instead of solid copper until case exit.

The advantage of having a the line this way is that it is more versatile and can be pulled up or pushed back sligthly to make an easier fit on the socket since the new flexline is less flexible than the stock line and the evap assembly is alot bigger.

Another reason why Mouawad's may look cleaner is the drier position and the fact that the drier is polished. This machines drier sits behind the insulation hence no point in me trying to get in there with sandpaper and brasso.

I actually thougth the insulation job was great, next time just pop me a PM if there is something you are not happy about then I will do what I can.

In the end there is sidepanels on this machine so personally insulation looks did not come up as the 1st priority.

1st priority for me was spending a week tuning/adjusting/leaktesting this machine to produce the temps it delivers reliably while keeping the appearance good and neat.

If you want the insulation job redone then I will try my best to do it to your liking.