Quote Originally Posted by Wallynut View Post
Well last night I decided to remove all the copper heatsinks off my DQ6 and was shocked to see that the contact points where .
The P35 chip had decent contact but the TIM was rock hard. There was only 1 impression in the heatsink pad for the MOSFET modules around the CPU.

I had applied Artic TIM and also used some heat resistant o-rings on the nuts for the north bridge to add additional pressure. I felt there was too much movement for the block on the northbridge.
Normally I could put my finger on the heatsink and not feel much heat, now when I do this the heatsink is warm.

The standard TIM pads that are shipped with the motherboard obviously do not do what they are meant to do.

Normally I could put my finger on the heatsink and not feel much heat, now when I do this the heatsink is warm.


This is not good, if the heatsink is now only warm, it means that it is getting less heat into it than before, if it were hotter then it would be doing a better job of getting the heat from the bits on the motherboard.

Check your temps via software to see what they were before and now.