I recently painted the last L3 bridge shut on my
2400 but I can't seem to get it to boot if I change the multiplier. It's very odd even if I set the multiplier lower it won't work, it just stays blank after boot and forces me to clear CMOS. Is there something else I must do or have I just stuffed the painting of the bridge?
The really odd thing is that it no longer detects my processor as a 2400+ if left on default it calls it a 1700+ and sets the system bus to 100. Boots just fine if I set it to the 'right' settings though(calls it an AMD at 2006Mhz). I'm a little apprehensive about yanking my cooler off again it's a Thermaltake SLK-800 and that clip is an agent of the devil
Thanks for your time
Ben
Bookmarks