XP2100+ with your low OCing results only

[CoolLight]

I have seen many people having High OCing result with XP 2100+ processor recently, however I believe only the luckiest people get their processor OCed higher than 2300mhz STABLE.

To be fair, in this thread, I hope to get some information on the opposite side, so ONLY post here if you have/had an XP 2100+ that can NOT overclocked higher than 2300mhz.

Personally, I bought a XP2100+ DUT3C 0301 AIUHB green chip recently. Up to the highest Vcore 1.85V, The highest post speed is 2150mhz, the highest STABLE speed with Prime95 is 2100mhz.

I am using Alpha Pal8045 with 4000RPM Delta fan, Antec 430 TruePower, A7N8X Deluxe, Case temp 29C idle.

[mike.elmes]

In light of recent findings on overclockers.com......try a new battery in your mobo...it has fixed many a probs with that particular board.

mike

[CoolLight]

The fact is, I never experienced any instability problems with this motherboard. So, battery is not a problem here.

I just sold my 2400+ that can do 2.25Ghz with 192FSB on this board. With the new 2100+ CPU, it can barely stable at 2100mhz.

[Zputnic]

Well I got a Palamino 1900+ from the beginning so to say
It is stable in 2000+(1,66ghz) for about 40min-2hours with 1,95 no matter what.

I have a Alpha Pal 8045 /w Papst 80x80 19db fan on it, yes it is very silient , and I have like 45-47 on the core with max voltage. So I don't think its the temp either, got a Q-tec 450w power supply and a stick of Apacher pc2700 that can do 166-2-2-2-5 1t cmd, but i only run it at 139 when i try to overclock it. So I must have the worst of them all. =)