Best 1M on air?

[boblemagnifique]

Where did you get this M 780 from?...It does well on air....and on what mobo is it?......Thanks.......

Ebay (USA)
Big Typhoon
P4P800se (bios 1010 beta)

My New Superpi 1mo at the moment



I hope 23.1/23.0s with Eproom P4c (260/270 synchro Pat on) and Tornado or a Delta on Big Typhoon for benchs a 3150mhz

[Fixxxer]

That's with my FX57 + Mushkin Level II Old BH5.



I use a Thermalright XP90C.

[Vapor]

boblemanifique....there's no better cooler than the BT? Don't the heatpipes impede the OC with such low heat output (or is your Dothan really scorching?)?

[KenLau]

Venice 3200+ (0515 GPBW) on air with a Hyper 6
Super Pi 1M = 27.969

[hipro5]

Ebay (USA)
Big Typhoon
P4P800se (bios 1010 beta)

My New Superpi 1mo at the moment

[Gautam]

Very nice clocks Hipro. What sort of ambients do you have? Doesn't seem to be a large difference between the 770 and 780...

[boblemagnifique]

Very Good

Motherboad ?

I always have my problem blocked being has 239mhz pat ON even with Eproom of P4C800 dlx (vdd has 2.02v, does not change anything) I don't understand too much, I hope at least 260mhz pat On but that will be 239/240mhz max one would say well

[hipro5]

NO This was not on air......It was with a prommie on CPU and with an ASUS P4P800SE mobo......I posted for comparison reasons with the Rams....

P4C800 with 875 chipset is much beter than the P4P800 and 865.....

This is with a P4C800E-Deluxe mobo with Rams @ 260MHz all Turbo and on AIR.......I think I could gain another 5 - 7MHz more out of it on Rams if I put it under a Prommie......

http://service.futuremark.com/compare?2k1=8755934

[hipro5]

On 3.2Vdimm AND PAT Enable is NOT possible......IF it was possible, then your rams could do OVER 285MHz at 1:1 without PAT.....CAN they do it?......

The worst I could do at the same frequency is this......As much as I tried, I couldn't do worse....



ALSO to much your score, I MUST be about 30+ MHz lower than you.......




.......and a little challange......

Do this at the same frequency with WHATEVER (PAT ON or PAT OFF) timmings, Voltages, e.t.c. you can.......



http://valid.x86-secret.com/show_oc?id=43999

[hipro5]

They do 290+ on an NF4 mobo.............

Do you have any screenie that they do 290MHz on an Intel mobo?

[Fixxxer]

I improved my results ^^u

[alexio]

I have 25.969 exactly with a Dothan 740. I'll go outsite toninght and see if I can beat you. Still stock cooler and no mods though

Any one willing to mod a P4P800-SE for me?

[sang]

very nice results,Hipro_5

I'll put my results here especially since i have a 3090Mhz run,to make a comparo with you.

I'm on the ty P4GD1 though


AIr Cooled by -1 C and Swiftech MCX462 + Tornado 119cfm.

[hipro5]

Nice........

This was done with the P4GD1 mobo?....

[Gautam]

Memesama

I take it the P4GD1 doesn't have an equivalent of DRAM parameter 11...get yourself a P4C800-E Dlx and then you'll really see Pi scream.

[hipro5]

Heh,heh,heh.......At 3135MHz, I have a better score.......

[sang]

Memesama

I take it the P4GD1 doesn't have an equivalent of DRAM parameter 11...get yourself a P4C800-E Dlx and then you'll really see Pi scream.

yeah,i knew about it.
That's why i hate GD1.
I love it for only one thing: she let me run 285x11 1:1 with my 2*512 Corsair 2-2-2.

[s7e9h3n]

Well, there's no way to compete with the Dothans, but here's my FX55 (coded with a FX57's CPUID - See sig) on a coolermaster Hyper6. THere's more left in memory, but it'll take a little more tweaking:

[Gautam]

Heh,heh,heh.......At 3135MHz, I have a better score.......

Is that 1 GB with 200 1:1 latency 11?? I don't think I've ever seen anyone else do that...I run it fine with 2x256 up to about 265MHz but with a gig, that's crazy.

[hipro5]

Is that 1 GB with 200 1:1 latency 11?? I don't think I've ever seen anyone else do that...I run it fine with 2x256 up to about 265MHz but with a gig, that's crazy.

It's with 2 x Kingston Value Rams DDR333(PC2700) BH-6 and Full PAT - Turbo - boot @ 200MHz (11)and 1:1.........You DON'T gain more with 2 x 512MB rams as many people believe, coz with the 2 x 256MB you can "force" them much more (Turbo - 0T - 15.6uS - Enable - e.t.c.) than 2 x 512MB ones........

One of these days, I'll test 2 x 512MB OCZ PC3200 VX to see how they are doing.........On AS8 they did 262MHz with 3.3Volts........

[sang]

Hipro5

I think your chances to run >240 FSB 2x512 UTT in a C800 are close to zero,but we never know until you try it.
I really would like to see a 3D2001 run in a C800 with your CPU over 3100MHz (it will be perfect @3200MHz) and with your x800 XTPE.Clocks for Radeon doesnt matter so much, i just want to compare your CH,LL with my run on P4GD1.
Here is mine:
http://service.futuremark.com/compare?2k1=8756918

Thanks.

[Gautam]

It's with 2 x Kingston Value Rams DDR333(PC2700) BH-6 and Full PAT - Turbo - boot @ 200MHz (11)and 1:1.........You DON'T gain more with 2 x 512MB rams as many people believe, coz with the 2 x 256MB you can "force" them much more (Turbo - 0T - 15.6uS - Enable - e.t.c.) than 2 x 512MB ones........

One of these days, I'll test 2 x 512MB OCZ PC3200 VX to see how they are doing.........On AS8 they did 262MHz with 3.3Volts........

Could you please show us an i865 tweaker shot? I'm extremely impressed...I always thought you were using 2x512...and even still excellent for that...but 2x256 is crazy. Best Dothan Pi tweaker I've seen so far by a long shot. What do you think I was doing wrong in this run? I think I had that setting at 4T or something...didn't realize how important it was.

[hipro5]

Could you please show us an i865 tweaker shot? I'm extremely impressed...I always thought you were using 2x512...and even still excellent for that...but 2x256 is crazy. Best Dothan Pi tweaker I've seen so far by a long shot. What do you think I was doing wrong in this run? I think I had that setting at 4T or something...didn't realize how important it was.

Thanks a lot.........

865 Tweaker is like yours........

Also I put in Bios Turbo , 2-2-2-5 , 4, Enable, 0T, 15.6uS .........Also NO maxmem.........and ALL of the PCI Latencies at 0 cycles( if you want it, you can get it from H E R E . I also tweak Windows and NEVER run Super-Pi in diagnostic mode with the Dothans.......and of caurce ASUS P4C800E-D and not P4P800SE......865 is not that good.......

[hipro5]

Hipro5

I think your chances to run >240 FSB 2x512 UTT in a C800 are close to zero,but we never know until you try it.
I really would like to see a 3D2001 run in a C800 with your CPU over 3100MHz (it will be perfect @3200MHz) and with your x800 XTPE.Clocks for Radeon doesnt matter so much, i just want to compare your CH,LL with my run on P4GD1.
Here is mine:
http://service.futuremark.com/compare?2k1=8756918

Thanks.

Thats a preaty good score.........

This weekend I'll put it under a prommie and I'll tell you how it does.......This VGA has done under a prommie Core= 785MHz and Rams=702MHz.......I think under a cascade(prepairing now) will do about Core=850MHz+ and Rams= 710MHz+.......

EDIT: LL NEEDS high overclocked VGA's.........LH doesn't......

[kiko]

Thanks a lot.........

865 Tweaker is like yours........

Also I put in Bios Turbo , 2-2-2-5 , 4, Enable, 0T, 15.6uS .........Also NO maxmem.........and ALL of the PCI Latencies at 0 cycles( if you want it, you can get it from H E R E . I also tweak Windows and NEVER run Super-Pi in diagnostic mode with the Dothans.......and of caurce ASUS P4C800E-D and not P4P800SE......865 is not that good.......

for comparison could you please give a run w/ your P4C800-E at 216*12? [my booster is "out of order" ATM]
That is my best run w/ P4P800D [1007.003 P4P800-E bios] turbo 2 2 2 5 8 E 64T 64us MAXMEM=104 OS: 2K3 server



Ciao