How to make 2x512 utt and bh5 sticks to post on dfi nf4-sli?

[Kesker]

Hello all,this is my first post here

I have two 512 mb good sticks(One is classic bh5,other is twinmos utt,both of them has 3200 spd)and want to match them ,actually i managed to do this before.I cant remember what settings i used,but the bios was either 310 or the stock bios which is older than 217.



It isnt a cold boot problem because i can dual two utts.

Any help ,especially from dfi reps appreciated

[don_vercetti]

try single channel, apparently lots of problems with that.

[turtle]

I've never gotten my bh-5 to work with my utt...of course i've only tried dual channel (because that's 939's purpose). I figured it was a mem controller issue. I thought I heard rev E cpus could handle the mis-match, but I could have heard wrong, or from an unreliable source.

If someone knows the solution...I'd be intrigued to know as well.

edit::: I suppose bh-utt would probably work with bh-5....Have not tried (have vx..ch-utt) but it'd make sense...as the bh-utt can handle the lower settings bh-5 can handle but ch-utt can't (be it lesser important timings). Could be wrong though...