Hi there,

today I got my new 1GB pair of Micron 5B-G based PC3200 RAM. Well, I'm just trying to get it to run decently on my DFI LanParty UT Nforce3 250GB, but to be honest, it performs kinda crappy.

Everything past 2.8V causes memtest erros and the RAM runs best at 2.5V and gets quite hot, even at that voltage.

If you are running Micron RAM on that very board, then please post here what BIOS version you've got intalled, what other hardware you use (CPU and so on) and if you made any special settings.

I do think that I'm missing something, as this RAM should be able to run far better (3-2-2-x at 250MHz, posts without problems at that setting, but erros like hell). Right now, all I can get is 233MHz at 3-4-4-x (didn't test much, but that's error free for sure).

Thx in advance!

Greetings from Bavaria

Ingmar