-
Which DC PS for running AquaXtreme 50Z @ 13.8V
I was looking at a couple of power supplies for running my 50Z @ 13.8V.
Could anyone here with some experience of running this pump @ 13.8V on a PS recommend either one over the other?
http://www.maplin.co.uk/Module.aspx?...ldID=&doy=18m2
http://www.maplin.co.uk/Module.aspx?...ce=14&doy=18m2
-
Xtreme X.I.P.
the second one would prolly be better as you can get a higher amperage one.. should have a little headroom in the psu so it isnt working near max capacity all the time.
-
50Z draws less than 1A, even at 13.8V, I'd say go with the 3A model on the second page, it's rated 2A continuous - you don't need any more power than that.
BTW maxxx, those PSUs are designed to work at their max continuous rating all the time, leaving headroom is just wasting money.
-
OK, thanks. I'll go for the 2A one then.
-
Xtreme X.I.P.
butcher. I wasnt suggesting the 10 amp or anything. I liked the 5 amp one (4 amp would be best i think) so that way you could run other components off of it if you ever wanted to. like say a second 50z.. hehe.. Upgradability is something to think about, especially when the increase in price for it is very small like in this case.
The only issue i have with a bigger psu on it is that they will most likely disipate a little more heat...
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Bookmarks