Question the NEO2,Corecenter and phasechange cooling

[DragonFire]

Forgive me if this should have been under Phasechange cooling, I wasn't to sure which place would be better.

Anyways, I was wondering if NEO2 owners that are using phase change cooling could tell me what temps corecenter reports under full load?

I know the readings can't be trusted but do any of you see a 20+C temp increase from idel to full load?

[AKRedneck]

40°C all the time with my Mach1...full load, idle, high volts, low volts. Well maybe I see 39° once in a blue moon but otherwise it's frozen at 40°. It's meaningless. From idle to full load I see about 6-7° difference on the Mach1 evaporator readout, but that may not be real accurate either..

[DragonFire]

I knew the readings were a little messed up but geez.....While I'm not using phasechange cooling, I am using a watercooler that is outside so the water is chilled nicely. I'm seeing 25-30C idel with my FX-55 at stock but as soon as I start Prime95 it shoots up for 55-64C!!