1 HC enough for CPU block and MCW50-T ??

[Nimrod0031]

I have a TDX cpu block that will be cooling a 3400+ overclocked and a MCW50-T I might slap on there. The heatercore I will be using is a 1976 chevette heatercore w/ a 130cfm JMC fan.

I use too run a setup like this on a P4 but with dual rads and I dont know what to expect from a single Rad. If worst comes to worst I have a BIX MICRO 2 that I could add in if you all think that would help alot.

Thanks

[afireinside]

I have a Dtek heatercore (the procore, not the smaller one they sell now) with an 80CFM fan on it cooling a maze4 on a 2.53ghz 1.82V tbred and a 411mhz core 9500pro with a maze4+80 watt TEC and it worked fine but the water got HOTT! Upwards of 40C running 3dmark according to the probe in my res after the GPU block IIRC. You might be ok because you have a much better fan but I'd throw in another radiator of some type or a dual core to be safe.