-
Need help for PSU Vsense mod
All modders, this time need help
i just followed all the ways that u guys discussed in other forums about modding Antec TP550W Vsenses
3.3V = 10ohm fixed + 1k VR
5V = 33ohm fixed + 10k VR
12V = 68ohm fixed 10k VR
After modding, the PSU could turn on, but after several minutes of running, it shut off itself
i've set all the voltages near to default voltages 3.4/5.2/12.3V
this must not the problem of overvoltage, then i tried touching the VRs, the 5V and 12V VR got very hot, so i think the wattages of the VRs that i've chosen was not high enough (only 0.5W), but i dont know what the value of watt of the VR must have for this mod, anyone knows that???? if so, where to buy those VR?
-
0.5w VR is plenty.
Make sure that your sodler joints are solid to begin with.
Also, when you put the fixed resistor inline between the sense leads that you cut...did you solder a wire to the top leg of the fixed resistor...and that wire ran to the middle leg of your VR? And, what are you using as your ground point?
Pics would be very helpful.
I like my women the way I like my processors...naked.
I am not the HellFire that writes bios files. I work strictly on voltage modifications.
-
i've sent all of my modding photos to ur e-mail provided to me last time, so plz check out
plz comment on what i did wrong there plz, Hell-fire
thx very much!!!!!
-
vaspey, have you gotten your psu mods worked out buddy?
I like my women the way I like my processors...naked.
I am not the HellFire that writes bios files. I work strictly on voltage modifications.
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Bookmarks