the dimensions of the evaporator are 24cm high and 38cm long.
the condensor is 44cm long and 33cm high.
next think i have to do is find an eski that i can fit that evaporator in. i think i will get one of those desk fans and make a shroud for it as with the original fan its a little loud and place it on the condensor to cool it down as it does get hot running without the fan. (like 63db of noise), with out the fan it sounds like a fridge (alot better)
well the system is almost up, just got to insulate the maze4 block for the gpu (top side of block) and i can start to oc, at the moment im getting a small pudle of water from the condensation.
i ran the air conditioner for one hour to pull the temperature of 20m liters of nulon coolant down to 0deg. then shut it off.
just sitting there it took 5 hours before it rose to 1deg in the eski. i ran the sytem for 2 hours cooling the peltier and the coolant rose to 10deg. i then ran the airconditioner for 15 mins and it brought it back to zero.
i cooled the water to 0 deg then the very next day it had one rose to 15degs.
Originally posted by kayl well the system is almost up, just got to insulate the maze4 block for the gpu (top side of block) and i can start to oc, at the moment im getting a small pudle of water from the condensation.
i ran the air conditioner for one hour to pull the temperature of 20m liters of nulon coolant down to 0deg. then shut it off.
just sitting there it took 5 hours before it rose to 1deg in the eski. i ran the sytem for 2 hours cooling the peltier and the coolant rose to 10deg. i then ran the airconditioner for 15 mins and it brought it back to zero.
i cooled the water to 0 deg then the very next day it had one rose to 15degs.
just curious why would you want to run your chiller in this manner?
cause i dont have anti freeze.
today i switched to nulon anti freeze to chill down to -20deg in 2.5hours
i insulate the graphics card block because it has condensation forming on the back
Bookmarks