ASUS Z97 Motherboards - Official Support Thread

[FlanK3r]

?btw, with Turbo V Light I have sometimes issues, cant chage the values, must to set back, apply and again set higher value. SOmetimes this cycle is for 3x or 4x. Sometimes OS frozed. Any tips or older versions are better?

[Dumo]

M7I+Pentium and Samsung








Colder and moar volts on Impact Power II

[FlanK3r]

woah, CPU cache voltage over 2V?!

[l0ud_sil3nc3]

woah, CPU cache voltage over 2V?!

Looks like LN2 profile 3 was loaded

[FlanK3r]

Gene of Impcat for LN2? Any advice? I want not focusing at LN2 memory, only CPU with LN2....

[Dumo]

Both boards capable to take it up

[FlanK3r]

So Gene, I need something bigger for better feeling of me

[Alex-Ro]

Just finished reviewing the M7 Formula,impressive board for sure:

http://bit.ly/1rIXA8C

[NoM$_YesLinux]

Someone has an XP UEFI for Z97-Deluxe and Z97-A?

[Alex-Ro]

Maximus VII formula doing fine 2933 c9 with right mems

[Dumo]

M7I, pentium cold and bbse air

From a bunch of pentiums only 3 can do imc with rtls and only 1 can do tight trdwrs. Board and rams go as high as imc can scale

[TaPaKaH]

testing M7G with PSC, G3258:



4770K:

[kagula323]

M7I, pentium cold and bbse air

From a bunch of pentiums only 3 can do imc with rtls and only 1 can do tight trdwrs. Board and rams go as high as imc can scale

Verry nice Dumo. What DDR voltage you used for those BBSE?

[Dumo]

Verry nice Dumo. What DDR voltage you used for those BBSE?

Thanks kagula. 1.895V

[TaPaKaH]

PSC 1400 air on M7G:



Had to use G3258 for these runs. Same settings with 4770K will need about 0.02V more, but voltage hole at 1400 drops like an anvil from 1.90 onwards on this particular set.

[Alex-Ro]

Maximus VII Impact+Corsair samsung,tightest tertiary and lowest volts so far:

[Shiranui Gen-An]

Maybe I should try Samsung since I don't have much luck with PSC and BBSE, I have some 2666C10 Platinums that have gone neglected for some time.

[FlanK3r]

I think, this risk was with cold at RAM? Im so jittery use more than 1.8 V at AIR to DDR3.

[Shiranui Gen-An]

Samsung can take the volts.

[Splave]

too many air mem results! someone freeze it already lol :P

[bullant]

Hi,has anyone done any cold PSC on the M7I? Just wonder what its like

[BarboneNet]

Sam what were RTL's for the Samsung runs?

Took me a minute on how to get them to 42, 43, 4, 4 but here's how I do it.

Boot into bios and set bclk to 96.3 then save and reboot back in to the bios. Now set MRC fast boot to disabled and then set initial RTL to 47 and save settings. Once again reboot in to the bios to confirm that RTL's are 42, 43, 4, 4 and then enable MRC fast boot so the it doesn't try to to retrain.

Then boot in to windows and raise bclk to 100 with Turbo V light, and bingo proper Samsung RTL's.

Hope this helps someone

hi loud......if i do this tips, i can't set bclk at 100.00!!! i arrive only at 99.....after that, systemfreeze! thanks

[FlanK3r]

M7H and only air testing with Gelid Tranquillo r1


Seems not bad chip . In last OCCT was very, very hot, I used 3000 rpm fan. But its better than I hoped (my tip was around 4650-4700 MHz).








final OC stable 4800 MHz:


How perform it in CPU part in game? Of course I use lower resolution which is still a bit limited by CPU and very high physics + high details.

First at stock, look at average and lowest FPS


After OC to 4800 MHz, not bad, right?

[Alex-Ro]

Maximus VII Impact memory madness,samsung DDR3-2933 8-12-12

[PatRaceTin]

Any news about Asus Z97 Extreme ? ( I see only Z97 Formula ).