I picked up a LD setup and the insullation directions are pretty much art eraser, neoprene, paper towel, and insullation tape. Will the pins not eventually get moist and damaged with nothing protecting them?
I picked up a LD setup and the insullation directions are pretty much art eraser, neoprene, paper towel, and insullation tape. Will the pins not eventually get moist and damaged with nothing protecting them?
4930K @ 4.8 @ 1.4v in Rampage IV BE w/ EK RIVBE Blocks
4 x 780 TI Classifieds w/EK acetal/nickle full cover blocks
32GB Corsair Platinum 2666
Corsair 1500w AXi
Lil' Devil Black Reverse SS Phase Case
2 x XSPC RX480 v3 w/Gentle Typhoon 1850 and 1 x XSPC EX120
Mailstrom Res w/ 2 x MCP35X, EK dual acetal MCP35X top with two MCP35X
7/16" x 5/8" Primochill LRT Black with EK Compression fittings
1 TB and 512 GB Samsung EVO 840 and 4 GB W/D Black
Maybe, depends on how much air you are trapping and whether or not that's any different than standard exposure to air seen in ambient conditions.
I've ALWAYS used dielectric grease though. Even with more modern insulation methods.
And I still find it easy to remove.... Just put the pcb in dish washer (no soap) then hair dryer and bag of rice.
If you have a cooling question or concern feel free to contact me.
Is there a preferred eraser brand? How many packages would you suggest for this?
[IMG][/IMG]
4930K @ 4.8 @ 1.4v in Rampage IV BE w/ EK RIVBE Blocks
4 x 780 TI Classifieds w/EK acetal/nickle full cover blocks
32GB Corsair Platinum 2666
Corsair 1500w AXi
Lil' Devil Black Reverse SS Phase Case
2 x XSPC RX480 v3 w/Gentle Typhoon 1850 and 1 x XSPC EX120
Mailstrom Res w/ 2 x MCP35X, EK dual acetal MCP35X top with two MCP35X
7/16" x 5/8" Primochill LRT Black with EK Compression fittings
1 TB and 512 GB Samsung EVO 840 and 4 GB W/D Black
We have a guide posted in the stickys
http://www.xtremesystems.org/forums/...sulation-Guide
Bookmarks